How to create a 3D jewellery set

What you require:

Results – These can be distinct dependent on private tastes:

Equipment:               

Star Assortment just before sharpening

Instructions:

  1. Initial you will need to saw/file the sprue off the elements
  2. You can pre buff/ pre polish the star pieces which can make cleansing a lot easier after soldering
  3. Using buff sticks to buff back again the forged end likely from coarse to fantastic
  4. At the time you have got to fine buff paper you can get started to polish working with luxi compound –blue for 1st phase with the calico mop
  5. There are information marks on the level of the star pendant and earrings you want to solder jump rings to
  6. You can file leap rings with triangular file to give them an angle at the ends so they sit flat against the level of the star
  7. Apply solder paste where by the tutorial marks are on the stars
  8. On the soldering block, press the soar ring from the stars information marks and use tweezers to hold the soar ring in place
  9. Working with the hand torch, warmth up the reliable star and once it is setting up to switch colour bit by bit move along to the jump ring so it will get to tempreture at identical time right until the solder melts and joins the items alongside one another
  10. Quench and set it in pickle, rinse soon after pickling to wash off acids.
  11. If you didn’t buff and pre polish formerly now you will want to buff again the cast end and if you will need to take away any more solder
  12. Polish the piece employing luxi compound – blue for to start with phase working with a calico mop
  13. Then polish with White luxi compound and a fluffy mop
  14. For your earrings you can open up your ear wire and then near it back again alongside one another
  15. For the star pendant necklace, dependent on the bail you choose you can possibly include it straight the the leap ring or if needed you may well need to have to increase an additional more compact soar ring right before the bail.
  16. Ultrasonic or clean up off any residual polish and add a chain to the pendant.
Finished Jewellery Set

Optional: you can either totally shut your findings by soldering them through soldering step 9 or leave the conclusions semi open and just pushed with each other .

Save this for later on

Author: Amarah Mann

Leave a Reply